0 Results: in Bulart 3314, VIC

Removed from JD 4240 to fit a 3PL rocker housing. Item stored outside but under the cover Over parts pictured can be included/Sold separately Can assist with freight

Electronic valve faulty. Cooler side worked fine. Ideal for refurb or parts

Light Scarifier, Would work well with wide points for small weed suppression. Well Built machine Spring steel style tynes. Comes with 50 bolt on points Transport axles U-bolts replaced Comes with replacement wing U-Bolts Have Contacts for transport. Can Load Gringegalgona, VIC

1325 x 2250 x 600 Steel rack 780 high Has internal shelf Can assist with delivery within 1.5 hours

2700x 1970 x 1600 high Holds 10 chooks Available late June can deliver for extra

Removed from Iveco powerstar 2002 cab for wrecking. Postage extra

• 0 km

Fork tube kit to fit k 1100 LT and similar models. Brand new tubes x 2 and 4 seals

3 piece lounge with 2 recliner chairs in very good condition.

Had a full Reno, new wheel, bearings, repainted and done up inside also. Wired solar panel and converter to run off grid. Lots of storage under both beds. Annex in great condition however fly wire in some spots needs redoing. Super van to enjoy regular getaways. Genuinely selling, too good of a van to not be getting used enough! Please message me on for more information.

• Single Hull
• 15 ft
• Bertram

FOR SALE, is my Bertram v15 boat it is a very regrettable decision to sell as i was restoring this classic deep vee reverse chine hull boat , i have gone right through it and it is in very good seaworthy condition the transom is as solid as the day it was built , i have had a totally new 19mm marine ply floor installed professionally , i have cleaned up the exterior of the hull , fitted a 70 hp Evinrude out board with as new s/s prop , with all new steering cables and helm and steering wheel ,